Home

Products

Omni Stick

Contact

Purchase

Repair, Mend, Install:

Directions:

ACID FREE!  -  WATERPROOF!  -  PAINTABLE!  -  DRIES CRYSTAL CLEAR!

Hammerhead Omni-Stick™ adhesive works great on almost anything! Use on Ceramics, concrete, cork, felt, fiberglass, glass, leather, metal, most plastics, most rubbers, paper, porcelain, textiles and wood. It dries fast & clear and won’t stick your fingers together. It is washable and dishwasher safe and will not stain textiles. It is easy to use indoors and outdoors. It is flexible when drying. It is UV stable. The Maximum temperature it withstands is 275º F.

  1. 1. Remove Cap

  2. 2. Utilize cap to pierce top of tube by turning cap over and pressing down.

  3. 3. Screw white snip tip onto neck of tube. Snip end for desired flow. (The further down the tip, the wider the flow.)

  4. 4. Squeeze tube from bottom up with gentle pressure.
    NOTE: If glue does not flow, clean opening

  5. 5. Be sure surfaces are clean, dry and free of oil or grease.

  6. 6. Apply to one surface only. Slick surfaces may be roughened with sandpaper before gluing.

  7. 7. Press surfaces together. If a quick bond of 40 seconds is needed then pull back about 1/2” and repress. Repeat several times. Supports light loads in 10-15 minutes; allow 24 hours for heavy loads. Fully cures in 24 hours.

  8. 8. Clean nozzle thoroughly BEFORE replacing cap.

  9. 9. Test questionable surfaces before use. Can be used on vinyl surfaces when etched. Waterproof after cured.

  10. 10. Nail polish remover or paint thinner may be used as a cleaner.

  1. • Household

  2. • Workshop

  3. • Crafts

  4. • Automotive

  5. • Marine

Welcome_To_Hammerhead_America.html

Omni-Stick